Getting Started

Wake-on-LAN (WoL) allows you to wake up the offline remote computers in your Remote Desktop account, for establishing a remote connection.

To wake up your offline remote computer,

  1. Sign in to the Remote Desktop viewer with your credentials.
  2. Click three-dot-icon corresponding to your offline computer.
  3. Select 'Wake Up' and click 'Confirm'.

Note: To successfully wake up an offline computer, at least one of the other computers added to your Remote Desktop account must be online and on the same LAN.


System Requirements for Wake-on-LAN

To successfully wake up a computer via Wake-on-LAN, ensure the following settings and hardware requirements are fulfilled:

  • Network card that supports Wake-on-LAN.
  • Active internet connection.
  • Connected to the Internet via LAN cable.
  • Computer should be in any of the following power states:
  1. Sleep
    Start > Sleep
  2. Hibernate
    Start > Hibernate
  3. Shut down (Soft off)
    Start > Shut down
  4. Remote Desktop

After ensuring the computers meets the above requirements, you can proceed with configuring your Windows machines for WoL.

Set up Windows

To wake up a computer via WoL, you should enable WoL in BIOS settings and configure network card.

To enable WoL in BIOS settings,

  1. Switch on the computer and press ESC, F1, F2, F8 or F10 during the initial startup. Depending on the BIOS manufacturer, a menu would appear.
  2. Go to the 'Power' tab and enable 'Wake Up On LAN'.
  3. Save and exit the BIOS setup.
    Remote Desktop

Note: If there is no option to enable Wake-on-LAN in BIOS setup, refer to the motherboard manual to ensure your computer supports Wake-on-LAN.

Configure Network Card

The network card must be configured in such a way that the power is supplied all the time.

To configure network card,

  1. Click 'Device Manager' displayed on the left navigation bar.
  2. Right-click on 'Network adapters' and click 'Properties'.
  3. Go to the 'Power Management' tab and enable 'Allow this device to wake the computer' option.
    Remote Desktop

Note: The configuration steps may vary depending on the network card and operating system.

Configure Windows 8

In Windows 8 OS the standard shutdown procedure puts the computer into hybrid shutdown state as Windows 8 does not support Wake-on-LAN for this state. Hence we recommend you to deactivate the fast startup. Once fast startup has been deactivated, the computer will always be put into hibernate mode during shut down.

To deactivate the fast startup,

  1. Switch on the computer and go to 'Control Panel' -> 'Power Options'.
  2. Click on the 'Change what power buttons do' option on the left menu bar.
  3. Disable 'Turn on fast startup (recommended)' option displayed in the 'Shutdown settings' section.
    Remote Desktop